Cleaning S (Small)
Cleaning S (Small) is used once a year for unproblematic pools. If your water is dirty turbid, you can perform cleaning S as the first solution. Cleaning S can be skipped in case of very poor quality, e.g. large, oily bubbles, and cleaning XL can be performed.
Required products
- SpaBalancer SystemFlush
- SpaBalancer pH-Minus Granulate
- SpaBalancer Digital pH-Tester
One bottle of SpaBalancer SystemFlush is sufficient for a whirlpool with 1500 l water capacity.
Note: If you have cleaned the whirlpool tub with SystemFlush, you cannot dispose of the old water in the garden.
Important: It may happen that SystemFlush does not remove all deposits and only partially dissolves them. This can lead to cloudiness and water problems after refilling. In this case, we recommend cleaning L.
Application
Raise the water level by 5 centimetres before adding SystemFlush to the water.
Lower the pH value to 6.0.Leave the filters in the spa.
Start all pumps and pour the bottle of SpaBalancer SystemFlush into the water. Switch the pumps on and off at short intervals (10 - 20 seconds) as often as possible.
If brown deposits appear on the foam, skim them off.
Leave SystemFlush in the pool until no more brown deposits form. (May take up to 5 days).
During this time, rinse the filters daily with water and the filter spray.
If the foam remains white, empty the whirlpool.Rinse the pipes thoroughly via the jets with a garden hose.
Rinse the pipes thoroughly via the nozzles with a garden hose.
Fill the whirlpool tub with fresh water.